Skip to main content

Posts

Showing posts from July, 2013

Ramadhan Datang Lagi :))

Salam Ramadhan kepada semua ! Hari ini sudah hari ke-11 umat islam menyambut Ramadhan.. Sesungguhnya kehadiran Ramadhan kali ini memberi banyak makna dalam hidup setiap insan yang menghargainya.  Hari-2 aku berpuasa di METC sangat berbeza dari tempat-2 yang aku pernah lalui.. Sekolah lah katakan.. Di sini masih menyediakan sahur tapi orang-2 yang rajin macam aku ni memang rajin sangatlah nak turun ambil makanan kan.. Haha Kebiasaannya aku bangun sahur sekadar memakan roti, kurma dan meneguk air.. Sekadar mengambil berkat bersahur.. 
"Sesungguhnya perbezaan puasa orang-2 Islam dan kafir adalah sahur.."
Dan di sini juga, aku belajar erti berdikari yang sebenar.. Bangun sahur sendiri kate ko.. selalu mak kejutkan.. :D
Keindahan lebih dirasai apabila kami berbuka puasa berjemaah di surau di hadapan apartment kami.. Yang istimewanya bila dapat makan di dalam talam beramai-2.. Meriah kan? Memang jelas terasa bezanya apabila berkongsi makanan ni.. Selalunya bila makan sendiri meng…

Micrometer : Procedures

Micrometer is one of the precision instrument and it used to measure the thickness of a piece. There are four types of micrometer which are inside micrometer, outside micrometer, depth micrometer and screwthread micrometer.
There are certain procedures must be followed prior using the micrometer. Firstly, check the calibration tag and make sure tools calibrated. If it is not calibrated, send to standard room. There are several infos shown on the sticker which are serial number, part number, next due date, approval name and stamp. Check all these infos and make sure it is the latest date. Next, make sure the tool clean. Check for any defect such as corrosion and pitting on micrometer. After that, spin the ratchet screw to move the spindle close to the anvil. Check the scale to make sure there is no zero error. It is when the number zero '0' coincide. Then, check the smoothness of the movement of the spindle.
While using the micrometer, make sure the surface of the piece that i…